Clam Corp Fish Trap 8323 User Manual download pdf (Page 9)

To “set” the tent, grasp the tent material at the rear of the shelter and pull it downward. Observe the

porch area of the tent lifting accordingly as you pull. When the U-Channel molding is correctly installed,

the porch hoop pole will lightly touch the floor.

To achieve this condition, start by finding the center of the molding. From behind the unit, pull the

midpoint of the tent downward and fold the tent material under the base lip. Press the midpoint of the

molding over the tent material and base lip. Continue pressing outward in both directions until you have

secured about twelve inches of molding onto the base.

Having temporarily secured the tent to the base, take a walk around the unit. Readjust the molding until

you have verified the proper porch hoop pole position and also that the tent sides and corners are

properly proportioned.

When satisfied, continue applying the molding around the shelter, one direction from center and then the

other, pulling the material as you go so that surface is relatively wrinkle-free and snug. Use a side cutters

to trim the ends of the molding if they are not equal relative to base.

Reinstall the rear adjustable spreader pole to tighten the fit of the tent. If everything still looks good,

secure the molding with the #6 phillips screws. Evenly space them about every ten to twelve inches, and

also put a screw in the center of both corners. Since there aren’t any predrilled holes, it's advisable to

use a powered driver for this operation.

- Tips for Use -

IMPORTANT:

Trim

the edge

of the molding so it ends

approximately 6 inches behind

the centerline seam on both sides

of the shelter.

6”

1 2 3 4 5 6 7 8 9 10

No comments

Clam Corp Fish Trap 8323 User Manual Page 9